Search:

Home | Home & Garden | Home Security


Burglar Alarms Install Guide - How to in 4 Steps

By: Sandra Wilson

Let's suppose you are one of those very handy do-it-yourself type of person and you have chosen to install your own burglar alarm system in your home. If you found your way here, then you are looking online for some type of burglar alarms install guide to help you with the installation. This is probably a good thing which will help you get all the different steps of the installation done right.

Some general guidance on how to install a security system in your home follows. Keep up your search for an installation guide, especially if one did not come with the equipment you gathered. It is important to get more details than can be provided within this article although these following steps provide an overall view.

1. First step is planning the work to be done. For this you may find a floor plan of your home and a basic layout of outside hardscape and landscaping all laid out on a drawing will help you plan. Why the outside stuff too? Outside features can hide a burglar or deter him such as a nice thorny bush under the window. Look at the obvious places an intruder could enter your home. Obviously these are the windows, doors and maybe basement entries.

2. Now you know where you want all detectors, sensors and cameras, you need to lay out the wires. This will entail drilling holes in walls and studs unless you are able to run the wires through the attic. The basement is a possibility as well if you have one. Otherwise there may be much patching of walls if you have to tear them out a bit to get to the studs to run the wires. At any rate wherever wires go into the wall or out of it, you will have some patching or covering to do. Make sure you get your holes large enough for the amount of wires that must pass through them.

A time saver as well as work saver would be to go with a wireless system if you are able to get everything synched up. Much less work as there will be less to no drilling (depends upon how things like the keypad are mounted) and therefore less patching and clean up. You will need to decide if a wireless system is best for you or not.

3. Before yo start cutting the wires to run to the sensors, be sure that you have measure correctly and allowed for sufficient length to reach the sensor or camera and back to the control panel. Measure twice and cut once is the old rule that applies. Labeling the wire after you cut so that you don't use the wrong wire for the wrong detector is a good idea.

4. It is suggested that you place the alarm box or bell box up high and out of easy reach on the exterior of your home where it can be easily seen. This is the part that makes a lot of the noise. Just seeing this box can keep burglars from making an attempt at your home as they will know you have a security system in place.

Above we have provided some tips on important factors that you need to take into consideration when you choose to install your own security system. But with the help of a good quality burglar alarms install guide you should be able to get your own system up and running in a very short period of time. It is likely to cost you less than it would for a professional to install it for you instead.

Article Source: http://www.articlebankonline.com

Discover the burglar alarms install guide and many more resources on burglar alarm or security systems at our informative domain www.burglaralarmnotes.com

Please Rate this Article

 

Not yet Rated

Click the XML Icon Above to Receive Home Security Articles Via RSS!
Golf Gift Certificates from PurePoint Golf




Powered by Article Dashboard